Dell Latitude 131L User Manual
Page 106
106
Adding and Replacing Parts
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically
touching an unpainted metal surface (such as a connector on the back of the computer).
NOTICE:
To help prevent damage to the system board, you must remove the battery from the battery bay before
you begin working inside the computer.
1 Follow the procedures in "Before You Begin" on page 89.
2 Remove the hinge cover. See "Hinge Cover" on page 99.
3 Remove the six screws securing the display (two on the top, two on the bottom, and two on the back).
4 Disconnect the antenna cables from the Mini-Card.
5 Loosen the captive grounding-wire screw.
6 Disconnect the display cable, using the pull-tab.
7 Dislodge the display cable from the display cable channel.
1
screws (2)
2
display cable
3
display cable pull-tab
4
grounding-wire screw
5
antenna cables (2)
6
standby switch
7
display cable connector on
system board
8
display cable channel
2
3
5
1
4
7
8
6
book.book Page 106 Wednesday, April 4, 2007 7:31 AM