Dell Latitude 131L - Manual (Page 93)

Adding and Replacing Parts
93
NOTICE:
Hard drives are extremely fragile; even a slight bump can damage the drive.
NOTE:
Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell.
NOTE:
If you are installing a hard drive from a source other than Dell, you need to install an operating system,
drivers, and utilities on the new hard drive. See "Restoring Your Operating System" on page 84 and "Reinstalling
Drivers and Utilities" on page 82.
To replace the hard drive in the hard drive bay:
1 Follow the procedures in "Before You Begin" on page 89.
2 Turn the computer over, and remove the hard drive screws.
NOTICE:
When the hard drive is not in the computer, store it in protective antistatic packaging. See "Protecting
Against Electrostatic Discharge" in the Product Information Guide.
3 Slide the hard drive out of the computer.
4 Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE:
Use firm and even pressure to slide the drive into place. If you use excessive force, you may damage
the connector.
5 Slide the hard drive into the bay until it is fully seated.
1 screws (2) 2 hard drive
1
2
book.book Page 93 Wednesday, April 4, 2007 7:31 AM