Dell PowerVault TL4000 - Manual (Page 163)

Service Library: Reboot
Important: Some options of the Web User Interface take the library OFFLINE. This
inactive mode can interfere with host-based application software,
causing data loss. Ensure that the library is idle before attempting to
perform any remote operations that will take the library OFFLINE.
This page is used to perform a library reboot. There is a default time delay when
the Web User Interface page refreshes itself. This time should be sufficient to
reload the page. However, during a reboot, the connection to the library may be
lost. If the connection is lost, the user will have to reload the page manually.
Click the Reboot button to initiate the reboot.
Import and Export Media during Normal Library Operation
Import Media
Data cartridges can be inserted and taken out of a magazine while the library is in
operation. If the library contains an I/O Station, and you wish to import media,
follow these steps:
1.
From the OCP Main Menu, select Control > Open I/O Station. The I/O Station
will unlock itself. The I/O station slot opens, and the "Unlocking I/O station"
message displays. Wait for the "Insert/remove cartridge and close I/O station"
message to insert or remove the cartridge, then close the I/O station by gently
pushing the slot back into the left magazine.
Note: It is recommended to wait for the messages before you insert or remove
cartridges to ensure that the library is ready to handle the cartridges.
a77ug2
8
9
Figure 5-59. The Service Library: Upgrade Firmware page, showing one Ultrium 3 SAS Half Height V2 drive and one
Ultrium 4 SAS Half Height drive.
a77ug077
Figure 5-60. Service Library: Reboot page
Chapter 5. Operations 5-65