Dell PowerVault TL4000 User Manual
Page 57
– Bar code labels
– Foot pads (for desktop installation)
v
With every library that contains a SCSI drive:
– SCSI terminator (one per SCSI drive)
– SCSI library-to-host cable (if ordered by customer)
v
With every library that contains a Fibre Channel drive:
– Fibre Channel library-to-host/switch cable (if ordered by customer)
v
With every library that contains a SAS drive:
– SAS library-to-host cable (if ordered by customer)
v
Rack Mount Kit
Important:
If your library did not contain preinstalled drives, then install them
now. Refer to “Removing/Installing/Adding a Tape Drive Sled” on
page 10-3 for instructions on installing your tape drives.
Installing the Library Foot Pads (for Desktop Installation
ONLY)
If you intend to install your library in a rack, skip this step and proceed to
“Removing and Storing the Shipping Lock” on page 4-4.
Important:
Operating your library on a flat surface without foot pads may damage
your library or cause it not to function properly.
Six foot pads must be installed on the bottom of the library before the library can
be used as a desktop unit.
To install the library foot pads:
1.
Being very careful, lay the library on its side.
2.
Peel the adhesive from the back of each foot pad.
3.
Install the foot pads on the bottom of the library enclosure by pressing each
foot into one of the six areas ( 1 ) as shown in the figure below.
Chapter 4. Installation and Configuration
4-3