Dell Precision 690 - Manual (Page 140)

Alert! Power Supply Fan Failure —
Alert! Previous Fan Failures —
Alert! Previous Thermal Failure —
Alert! Previous Shutdown Due to Thermal Event — Ensure that nothing is blocking the airflow vents and that all the fans are properly
installed and operating correctly. Also, ensure that the processor heat-sink assembly is properly installed.
Alert! Previous Reboot Was Due to Voltage Regulator Failure — Contact Dell for assistance. See Contacting Dell .
Alert! System Battery Voltage is Low — Replace the battery. See Replacing the Battery .
Alert! Memory Configuration Mismatch. Please enter Setup for Memory Information details. —
Alert! Memory Risers must be installed as a set of four —
Alert! Uncorrectable Memory Error Previously Detected in DIMM_X/Y —
Alert! Operating in single channel debug mode. Please populate memory in matched sets for normal operation. —
Alert! Memory Built-in Self Test fails in DIMM_X/Y — See Memory Problems .
Alert! Invalid Memory installed. DIMMs must have Full DIMM Heat Spreaders — Ensure that you are using or have installed the full-
length heat spreaders correctly.
Attachment failed to respond — See Drive Problems .
Bad command or file name — Ensure that you spelled the command correctly, put spaces in the proper place, and used the correct path
name.
Bad error-correction code (ECC) on disk read — See Drive Problems .
Controller has failed — See Drive Problems .
Data error — See Drive Problems .
Decreasing available memory — See Lockups and Software Problems .
Diskette drive 0 seek failure — See Drive Problems .
Diskette read failure — See Drive Problems .
Diskette subsystem reset failed — Run the Dell Diagnostics. See Dell Diagnostics .
Diskette write protected — Slide the write-protect notch to the open position.