Media card reader, Removing a media card reader – Dell Precision 690 User Manual
Page 70
14.
Enter system setup and select the appropriate Diskette Drive option (see
System Setup
).
15.
Verify that your computer works correctly by running the Dell Diagnostics. See
Dell Diagnostics
.
Media Card Reader
Removing a Media Card Reader
1.
Follow the procedures in
Before You Begin
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
Remove the drive panel (see
).
4.
Disconnect the interface cable from the back of the Media Card Reader.
5.
Disconnect the other end of the interface cable from the system board connector labeled "USB." To locate system board connectors, see
System Board
Components
.
6.
Slide the sliding-plate lever to the right to release the shoulder screw and slide the drive carrier out of the drive bay.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer.
NOTE:
A floppy drive or Media Card Reader must be installed in the 3.5-inch drive carrier in order to be installed in a drive bay.
CAUTION:
Your computer is heavy (it has an approximate minimum weight of 55 lbs) and can be difficult to maneuver. Seek assistance before
attempting to lift, move, or tilt it; this computer requires a two-man lift. Always lift correctly to avoid injury; avoid bending over while lifting. See
your Product Information Guide for other important safety information.
CAUTION:
The computer stand should be installed at all times to ensure maximum system stability. Failure to install the stand could result in the
computer tipping over, potentially resulting in bodily injury or damage to the computer.
1 interface cable
2 Media Card Reader connector (USB)