Dell PowerVault DX6104 User Manual
Page 62
1.
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and
peripherals.
2.
Open the system.
3.
Remove the expansion-card riser 1 and any card installed in the riser.
4.
Locate the internal dual SD module installed on the IDSDM connector on the system board.
5.
If applicable, remove the SD card(s).
6.
Holding the tab, pull the dual SD module to remove it from the system board.
7.
Replace the expansion-card riser 1 and if applicable, replace the card in the riser.
8.
Close the system.
9.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Figure 25. Removing and Installing the Internal Dual SD Module
1. blue pull tab
2. SD card 1
3. SD card 2
4. dual SD module
5. connector on the system board
62