Installing the control-panel module – Dell PowerVault DX6104 User Manual
Page 78
Figure 36. Removing and Installing the Control-Panel Module
1. control-panel module
2. screws (2)
3. control-panel module connector cable
4. USB connector cable
5. control panel
Installing The Control-Panel Module
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1.
Insert the control-panel module into the slot in the chassis and align the two screw holes on the control-panel
module with the corresponding holes on the chassis.
2.
Secure the control-panel module with the screws.
3.
Connect all the applicable cables to the control-panel module.
4.
Close the system.
5.
Install the control panel.
6.
Reconnect the system and peripherals to their power sources, and turn them on.
7.
If applicable, install the front bezel.
78