Figure 4: md3000i iscsi initiator target portals – Dell PowerVault DL2200 User Manual
Page 10
Configuring the Dell™ PowerVault™ MD3000i Array as a Backup Target for Symantec™ Backup Exec™
Page 8
Configuring the PowerVault™ DL Backup to Disk Appliance Array Access
1. Click on
Start -> Administrative Tools -> iSCSI Initiator. The iSCSI Initiator properties dialogue
box appears. (Refer to figure 4)
2. Click on the Discovery tab. Click Add Portal and enter the IP address of the MD3000i.
Figure 4: MD3000i iSCSI Initiator Target portals
3. Click on
Targets tab and click Refresh. This will populate the iSCSI targets available to the DL
Backup to Disk Appliance. Contact your MD3000i SAN administrator if no targets are available.
4. Click on the desired target then click
“Log On”, and select “Automatically restore this
connection when the computer starts” and “Enable Multi Path”. (Refer to Figure 5)