Agp card brace (mini tower chassis only) – Dell Precision 330 User Manual
Page 2
Back to Contents Page
AGP Card Brace (Mini Tower Chassis Only)
Dell Precision™ WorkStation 330 Systems Service Manual
Removing the AGP Card Brace
To access some components on the system board in the mini tower chassis, you may need to remove the accelerated graphics port (AGP) card brace.
1. Turn off the computer and peripherals, disconnect them from their electrical outlets, wait at least 5 seconds, and then
remove the computer cover
.
2. Lay the computer down on its right side.
3. Remove the screw that secures the AGP card brace to the chassis (see the following figure).
Removing the AGP Card Brace (Mini Tower Chassis)
4. Rotate the brace up until it disengages from the card guide at the front of the chassis. Then lift the brace away from the chassis.
Replacing the AGP Card Brace
To replace the AGP card brace, perform the
in reverse.
Back to Contents Page
CAUTION:
Before you perform this procedure, see "
Precautionary Measures
."