Front-panel buttons, Desktop chassis – Dell Precision 330 User Manual
Page 36
Back to Contents Page
Front-Panel Buttons
Dell Precision™ WorkStation 330 Systems Service Manual
Desktop Chassis
l
l
Removing Front-Panel Buttons (Desktop Chassis)
1. Turn off the computer and peripherals, disconnect them from their electrical outlets, wait at least 5 seconds, and then
remove the computer cover
.
2. Lay the computer cover upside down, with the back of the cover facing you.
3. Remove the front-panel buttons:
l
To remove the 3.5-inch diskette-drive eject button, pull gently on the button until its clip disengages the front panel of the computer cover. Lift the
button up to free it from the cover.
l
To remove the power button, use a small screwdriver to push in the two plastic clips that secure the button to the computer cover.
When the clips disengage, the button comes free from the front panel of the computer cover.
l
To remove the reset button, use a small screwdriver to push in the three plastic clips that secure the button to the computer cover.
When the clips disengage, the button comes free from the front panel of the computer cover.
Removing Front-Panel Buttons (Desktop Chassis)
Replacing Front-Panel Buttons (Desktop Chassis)
Replace the front-panel buttons.
l
To replace the 3.5-inch diskette-drive eject button, rotate the button into the hole in the front panel of the computer cover and push gently on the button until
CAUTION:
Before you perform this procedure, see "
Precautionary Measures
."