Dell Precision 330 - Manual (Page 46)

2. Rotate the power supply back into position until the securing tab snaps into the release latch.
3. If you have a mini tower chassis, stand the computer upright.
4. Replace the computer cover and restart the system .
The system detects that the new memory does not match the existing system configuration information and generates the following message:
The amount of system memory has changed.
Strike the F1 key to continue, F2 to run the setup utility
5. Enter system setup, and check the value for System Memory. The system should have already changed the value of System Memory to reflect the newly
installed memory. If the new total is correct, skip to step 7 .
6. If the memory total is incorrect, repeat step 1 and step 3 of " Removing a Memory Module ." Check the installed modules to ensure that they are seated properly
in their sockets. Then repeat step 2 through step 5 of this procedure.
7. When the System Memory total is correct, exit system setup.
8. Run the Dell Diagnostics to verify that the memory modules are operating properly.
Back to Contents Page