Dell PowerEdge C6100 - Manual (Page 140)

140
Jumpers and Connectors
System Configuration Jumper Settings
The function of system configuration jumper installed on each system board
is shown below:
Figure 5-14. System Configuration Jumper
NOTE:
The * in the table of system configuration jumper describes the default
status and the default state is not active state.
Table 5-1. System Configuration Jumper
Jumper Function Off On
A ME Function
Disable for Debugs *Disable Enable
B Reserved for BIOS
PCI-E Setup - -
C BIOS Clear
Password *Disable Enable
D BIOS Clear CMOS *Disable Enable
E System Reset *Disable Enable
1 2 1 2 1 2 1 2
A
B
C
D
Disable
E
A
B
C
D
E
Enable
book.book Page 140 Thursday, March 4, 2010 4:38 PM