Dell PowerEdge C6100 - Manual (Page 74)

74
Installing System Components
Installing the Expansion-Card Connector
CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Place the expansion-card connector into the expansion-card bracket.
See Figure 3-12.
2 Replace the two screws securing the expansion-card connector to the
expansion-card bracket. See Figure 3-12.
3 Install the expansion card. See "Installing the Expansion Card" on page 71.
4 Replace the system-board assembly. See "Installing a System-Board
Assembly" on page 62.
5 Reconnect the system to its electrical outlet and turn on the system,
including any attached peripherals.
Mezzanine Card
Removing the SAS Mezzanine Card
CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2 Remove the system-board assembly. See "Removing a System-Board
Assembly" on page 61.
3 Disconnect all the cables from the mezzanine card.
4 Remove the three screws that secure the mezzanine card. See Figure 3-13.
5 Lift the mezzanine card out of the system-board assembly. See Figure 3-13.
book.book Page 74 Thursday, March 4, 2010 4:38 PM