Dell PowerEdge 2800 - Manual (Page 10)

8
Tower-to-Rack and Rack-to-Tower Conversion Guide
www
.dell.com | support.dell.com
Figure 1-1. Tower-To-Rack Kit Contents
Recommended Tools and Supplies
• #2 Phillips screwdriver
• 1/4-inch nut driver
• T-10 Torx driver (for removing and installing the front panels)
Conversion Tasks
Installing a rack kit involves performing the following tasks:
• Removing the bezel, feet, and cover
• Removing the control panel assembly and tower front panel
• Installing the rack front panel and control panel assembly
• Removing the trim panel
• Installing shoulder nuts
• Removing the rack doors
rack front panel
rack control
panel carrier
rack bezel
shoulder nuts (6) 6-32 x 0.312
Torx screws
(22)
Y1001bk0.book Page 8 Thursday, July 8, 2004 4:32 PM