Dell PowerEdge 2800 - Manual (Page 15)

Tower-to-Rack and Rack-to-Tower Conversion Guide
13
Figure 1-5. Drive Tray in Maintenance Position
2 Remove the control panel assembly.
a Orient the system as shown in Figure 1-6.
b Disconnect the control panel cable from the SCSI backplane.
c Inside the drive tray, open the control panel cable clamp. See Figure 1-6.
d Using a #2 Phillips screwdriver, remove the three screws that secure the tower control
panel assembly to the front panel.
e Slide the control panel assembly back away from the front panel and remove the assembly
and cable from the chassis.
NOTE:
While removing the control panel assembly, be careful not to damage the interface cable.
captive screw
drive tray
release lever
Y1001bk0.book Page 13 Thursday, July 8, 2004 4:32 PM