Dell PowerEdge 2800 - Manual (Page 23)

Tower-to-Rack and Rack-to-Tower Conversion Guide
21
Removing the Cable-Management Arm
1 Shut down and turn off the system you are removing and all peripherals attached to this
system.
2 At the back of the rack cabinet, disconnect and remove the AC power cable and all cables
connected to the back of the system and secured to the cable-management arm with the
arm’s Velcro straps.
3 Loosen the two captive thumbscrews securing the cable-management arm retainer to the
vertical rack rails. See Figure 1-11.
4 Disconnect the inner tab of the cable-management arm from the cable tray.
5 Disconnect the outer tab of the cable-management arm from the cable tray.
6 Pull the cable-management arm from the cable tray.
7 Remove the two captive thumbscrews that secure the cable tray to the system. See
Figure 1-11.
8 Remove the cable tray.
Figure 1-11. Removing the Cable-Management Arm
cable-management
arm
back of
system
captive
thumbscrews
(2)
latch on cable tray
Velcro strap
back of rack
formed metal tabs
captive thumbscrews (2)
tabs
Y1001bk0.book Page 21 Thursday, July 8, 2004 4:32 PM