Dell PowerEdge 2800 - Manual (Page 29)

Tower-to-Rack and Rack-to-Tower Conversion Guide
27
Figure 1-16. Drive Tray in the Maintenance Position
2 Remove the control panel assembly.
a Orient the system as shown in Figure 1-17.
b Disconnect the control panel cable from the SCSI backplane.
c Inside the drive tray, open the control panel cable clamp. See Figure 1-17.
d Using a #2 Phillips screwdriver, remove the two screws that secure the control panel
assembly to the rack front panel.
e Slide the control panel assembly back away from the front panel and remove the assembly
from the chassis.
NOTE:
While removing the control panel assembly, be careful not to damage the interface cable.
captive screw
drive tray
release lever
Y1001bk0.book Page 27 Thursday, July 8, 2004 4:32 PM