Dell 2330d/dn Mono Laser Printer - Manual (Page 18)

7. Install the toner cartridge assembly into the new imaging drum kit by aligning the white rollers on the toner cartridge
with the white arrows on the tracks of the imaging drum kit and pushing the toner cartridge in as far as it will go. The
cartridge clicks into place when correctly installed.
8. Install the imaging drum kit with the toner cartridge assembly into the printer by aligning the blue arrow guides of the
imaging drum kit with the blue arrows found in the printer and pushing the imaging drum into the printer as far as it
will go. The imaging drum kit clicks into place when correctly installed.
9. After you replace the imaging drum, you should reset the imaging drum's counter. To reset the counter, see the
instruction sheet that shipped with the new imaging drum kit.
10. Close the front cover.
Replacing the Toner Cartridge
You can determine approximately how much toner is left in your cartridge by printing the printer settings configuration sheet.
This helps you decide when you might need to order replacement supplies.
When the Toner low message appears, or when you experience faded print, remove the toner cartridge. Firmly shake it side-
to-side and front-to-back several times to redistribute the toner, and then reinsert it and continue printing. Repeat this
procedure multiple times until print remains faded. When the print remains faded, replace the toner cartridge.
NOTICE: Do not leave the new imaging drum kit exposed to direct light for an extended period of time. Extended
light exposure can cause print quality problems.
NOTICE: Resetting the imaging drum's counter without replacing the imaging drum may damage your printer
and void your warranty.
NOTE: You can still print for a short time after the Toner low message appears, but print quality decreases as the
toner level decreases.