Dell PowerEdge C2100 - Manual (Page 87)

Installing System Components 83
4 Install the integrated storage controller card in place. See Figure 3-15.
5 Connect the SAS data cable to the integrated storage controller card.
6 Close the system. See "Closing the System" on page 59.
7 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
RAID Battery (Optional)
NOTE: The information in this section applies only to systems with the optional
RAID controller card.
Removing a RAID Battery
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2 Open the system. See "Opening the System" on page 58.
3 Locate the RAID battery carrier and remove the two screws that secure the
RAID battery carrier on to the chassis. See Figure 3-16.
4 Pull back gently on the right edge of the battery bay and draw out the
RAID battery from the battery carrier.
5 Disconnect the cable between the RAID battery and the storage controller
card. See Figure 3-16.
book.book Page 83 Friday, November 8, 2013 11:29 AM