Dell Inspiron 13z (5323, Mid 2012) - Manual (Page 37)

Replacing the Memory Module(s) | 37
14 Replacing the Memory Module(s)
WARNING: Before working inside your computer, read the safety information that
shipped with your computer and follow the steps in "Before You Begin" on page 9.
For additional safety best practices information, see the Regulatory Compliance
Homepage at dell.com/regulatory_compliance.
Procedure
CAUTION: If you need to install memory modules in two connectors, install a
memory module in the connector labeled "DIMM A" before you install a
memory module in the connector labeled "DIMM B."
1 Align the notch on the memory module with the tab on the
memory-module connector.
2 Slide the memory module firmly into the connector at a 45-degree angle, and
press the memory module down until it clicks into place. If you do not hear the
click, remove the memory module and reinstall it.
NOTE: If the memory module is not installed properly, the computer
may not boot.
3 Turn the computer over and open the display as far as possible.
1 tab 2 notch
1
2
book.book Page 37 Monday, October 8, 2012 3:56 PM