Dell Inspiron 13z (5323, Mid 2012) - Manual (Page 87)

Replacing the Display Assembly | 87
36 Replacing the Display Assembly
WARNING: Before working inside your computer, read the safety information that
shipped with your computer and follow the steps in "Before You Begin" on page 9.
For additional safety best practices information, see the Regulatory Compliance
Homepage at dell.com/regulatory_compliance.
Procedure
1 Place the display assembly in position and replace the screws that secure the
display assembly to the computer base.
2 Connect the display cable to the system-board connector.
3 Route the antenna cables through the routing guides and slide the cables through
the slot on the computer base.
4 Close the display and turn the computer over.
5 Route the antenna cables through the routing guides at the bottom of the
computer.
6 Connect the antenna cables to the connectors on the wireless Mini-Card(s).
See "Replacing the Wireless Mini-Card(s)" on page 41.
Postrequisites
1 Replace the battery. See "Replacing the Battery" on page 33.
2 Replace the palm rest. See "Replacing the Palm Rest" on page 29.
3 Replace the keyboard. See "Replacing the Keyboard" on page 25.
4 Replace the base cover. See "Replacing the Base Cover" on page 19.
5 Follow the instructions in "After Working Inside Your Computer" on page 11.
book.book Page 87 Monday, October 8, 2012 3:56 PM