Dell PowerVault MD3000 - Manual (Page 58)

58
Installing Enclosure Components
CAUTION:
Always wear a wrist grounding strap when handling equipment with static-sensitive components.
1 Perform the following steps to install the new physical disk into the carrier:
NOTE:
Data from virtual disks created on a PERC 5 SAS controller cannot be migrated to an MD3000 or to an
MD1000 expansion enclosure connected to an MD3000.
a If you are replacing a physical disk in the carrier, remove the four screws that secure the disk to its
carrier and remove the disk (see Figure 4-3).
b Position the replacement physical disk into the disk carrier with the disk’s controller board facing
the rear of the carrier.
c From the rear of the carrier, slide the physical disk into the carrier until it contacts the stop tab at
the front of the carrier.
d Secure the physical disk to the carrier using the four screws removed earlier. To avoid damaging
the carrier, do not overtighten.
Figure 4-3. Installing a SAS Physical Disk in the Carrier
1 screws (4) 2 physical disk carrier 3 physical disk
3
1
2