Dell Studio 1569 (Late 2009) - Manual (Page 38)

Back to Contents Page
Power Button Panel
Dell™ Studio™ 1569 Service Manual
Removing the Power Button Panel
Replacing the Power Button Panel
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the
Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
Removing the Power Button Panel
1. Follow the procedures in Before You Begin .
2. Remove the battery (see Removing the Battery ).
3. Remove the two screws that secure the power button panel to the computer base.
4. Turn the computer over and open the display as far as possible.
5. Between the two hinges, pull up on the power button panel and lift it up at an angle to disengage it from the back of the computer.
6. Disconnect the power button cable from the system board connector.
7. Continue to pull up on the power button panel and remove it from the palm rest.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface.
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery ) before working inside the
computer.