Dell Studio 1569 (Late 2009) - Manual (Page 39)

Replacing the Power Button Panel
1. Follow the procedures in Before You Begin .
2. Connect the power button cable to the system board connector.
3. Slide the tabs on the power button panel into the slots on the palm rest and snap the power button panel into place.
4. Close the computer and turn it over.
5. Replace the two screws that secure the power button panel to the computer base.
6. Replace the battery (see Replacing the Battery ).
Back to Contents Page
1 power button cable 2 power button panel
3 palm rest
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.