Dell 2355dn Multifunction Mono Laser Printer - Manual (Page 36)

Appendix D. Additional functions 34
Appendix D. Additional functions
The following are additional functions you can use through EWS (Embedded
Web Service).
Printer properties settings
You can check and modify printer and document properties for an installed
printer. For properties that are not supported by the printer driver, an error
message indicating that the property is not supported is displayed. These
settings are used only for printing from this system to the printer. However,
these settings do not affect the printer properties of the network printer.
Firmware upgrade (HTTP)
You can upgrade your printer’s firmware using the HTTP protocol. First, you
need to download firmware from the Dell website (http://suport.dell.com.)
NOTE: Before upgrading the firmware, make sure that TCP/IP parameters are
entered in the print server.
1 Run your web browser and access Embedded Web Service.
2 Click Printer Settings Maintenance Update Print Server
Firmware.
3 Click Browse, and then select the downloaded new firmware.
4 Click Update Printer Firmware.
NOTE: It takes a few minutes to upgrading the firmware. After completely upgrade,
the printer will be reset.
Default setting (HTTP/SNMP)
You can reset all of your network parameter settings to their default status.
NOTE: All default parameters will be applied after the print server restarts.
IP filtering
This security feature (IP Filtering) provides the ability to prevent
unauthorized network access to the network print server based on IP
addresses set by a network administrator using EWS.
1 Run your web browser and access Embedded Web Service.
2 Select Printer Server Settings Other Features IP Filtering Enable.