Dell 2355dn Multifunction Mono Laser Printer - Manual (Page 59)

Appendix I. Regulatory statement 57
IMPORTANT NOTE: In the event that these conditions cannot be met (for
example certain laptop configurations or co-location with another
transmitter), then the FCC authorization is no longer considered valid and
the FCC ID cannot be used on the final product. In these circumstances, the
OEM integrator will be responsible for re-evaluating the end product
(including the transmitter) and obtaining a separate FCC authorization.
Antenna
These modular transmitters are for OEM integrations only. The end-user
product will be installed in such a manner that only the authorized antennas
are used.
Label and manual requirements for the End Product
For an end product using the DELL5002 there must be a label containing, at
least, the following information:
FCC ID for model DELL5002
The label must be affixed on an exterior surface of the end product such that
it will be visible upon inspection in compliance with the modular approval
guidelines developed by the FCC.
Where the DELL5002 will be installed in final products larger than 8cm x
10cm following statements has to be placed ONTO the device.
"This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation."
In case where the final product will be installed in locations where the end-
consumer is not able to see the FCC ID and/or this statement, the FCC ID
and the statement shall also be included in the end-product manual.
This device contains
FCC ID: A3LDELL5002