Dell OptiPlex 160L - Manual (Page 51)

6. Press out the securing clip at each end of the memory module connector.
7. Align the notch on the bottom of the module with the crossbar in the connector.
8. Insert the module into the connector until the module snaps into position.
If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.
9. Replace the computer cover.
NOTICE: Before touching anything inside your computer, ground yourself by touching an unpainted metal surface, such as the metal at the back of the
computer. While you work, periodically touch an unpainted metal surface to dissipate any static electricity that could harm internal components.
1 memory connector closest to processor
2 securing clips (2)
3 connector
1 cutouts (2)
2 memory module
3 notch
4 crossbar
NOTICE: To avoid damage to the memory module, press the module straight down into the connector while you apply equal force to each end of the
module.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.