Dell OptiPlex 160L - Manual (Page 74)

7. Unpack the replacement hard drive.
8. Check the jumper setting on the back of the replacement drive.
Ensure that the jumper setting on the new device is set for "cable select" (see the documentation that came with the drive for information).
9. Install the hard drive:
a. Place the hard drive in the bracket so that all three screw-hole tabs insert into the three screw holes on the hard drive.
b. Secure the drive to the bracket with the screws that you removed in step 6 .
c. Install the bracket into the computer with the two bracket-securing screws that you removed in step 6 .
1 hard drive
2 bracket securing screw
3 hard drive securing screw
4 drive bracket
5 bracket securing screw
NOTICE: Ground yourself by touching an unpainted metal surface on the back of the computer.
NOTICE: When you unpack the drive, do not set it on a hard surface, which may damage the drive. Instead, set the drive on a soft surface, such as a
foam pad, that will sufficiently cushion it.