Dell OptiPlex 160L User Manual
Page 81
10.
Gently slide the drive into place.
11.
Once the drive is in place, apply pressure to ensure that the drive is fully seated.
12.
Use the securing screw that came with the drive to attach the drive to the computer.
13.
Locate the data cable from the CD or DVD drive in the upper drive bay and connect its middle data connector to the new drive.
14.
Connect the drive's power and data cables to the system board.
15.
Check all cable connections, and then fold the cables out of the way to provide airflow for the fan and cooling vents.
16.
Reattach the front panel to the side hinges, and then rotate it until it snaps onto the front of the computer.
1 drive alignment screws (2)
2 drive
NOTE:
Some computers come with only two extra alignment screws; others come with four. You only need two alignment screws for this procedure.
1 securing screw
2 drive alignment screws (2)
3 extra drive alignment screws (two on certain computers)
NOTICE:
Match the colored strip on the cable with pin 1 on the drive (pin 1 is marked as "1").