Dell PowerEdge T110 II User Manual
Page 20
20
About Your System
Alert! Power
required exceeds
PSU wattage.
Check PSU and
system
configuration.
Alert!
Continuing
system boot
accepts the risk
that system may
power down
without warning.
The system configuration
of processor, memory
modules, and expansion
cards may not be supported
by the power supply.
If any system components
were just upgraded, return the
system to the previous
configuration. If the system
boots without this warning,
then the replaced
component(s) are not
supported with this power
supply. See "Power Supply" on
Alert! System
fatal error
during previous
boot.
An error caused the system
to reboot.
Check other system messages
for additional information for
possible causes.
BIOS
MANUFACTURING
MODE detected.
MANUFACTURING
MODE will be
cleared before
the next boot.
System reboot
required for
normal
operation.
System is in manufacturing
mode.
Reboot to take the system out
of manufacturing mode.
BIOS Update
Attempt Failed!
Remote BIOS update
attempt failed.
Retry the BIOS update. If
problem persists, see "Getting
Message
Causes
Corrective Actions
Coaster_HOM.book Page 20 Monday, November 3, 2014 3:23 PM