Dell Precision T3400 (Late 2007) - Manual (Page 188)

188
Adding and Replacing Parts
About Metal Shields (Present in Some Drive Configurations)
NOTICE:
If metal shields are present in your computer configuration, they must be
installed at all times while your computer is in use or your computer may not
function properly.
In certain computer configurations, metal shields are present in the drive bays
of your computer. If metal shields are present in your computer configuration,
they are essential and must be installed in the appropriate bays at all times.
NOTE:
If a metal shield is installed over a hard drive in the lower 5.25-inch drive
bay, and you install an optical drive in its place, a shield is not needed in that bay;
however, the metal shield should be kept in case it is needed later.
If you remove a hard drive, optical drive, media card reader, or floppy drive
from your computer, install a metal shield in its place. If a metal shield is not
installed in any of these cases, your computer may not function properly.
Contact Dell if you need an extra shield (see "Contacting Dell" on page 269).
Removing and Replacing the Metal Shield (Lower Drive Bays)
T O REMOVE A METAL SHIELD FROM A LOWER DRIVE BAY :
Slide the sliding-plate lever to the right and hold it in place as you pull to
remove the vented metal insert from the drive bay.
T O REPLACE A METAL SHIELD OVER A LOWER DRIVE BAY :
1 Align the metal insert’s two upper screws and two lower screws with the
corresponding slots inside the FlexBay.
2 Push the vented metal insert until it clicks into place and its metal tabs
rest flush against the chassis surface.
Removing and Replacing the Metal Shield (Upper Drive Bays)
T O REMOVE A METAL SHIELD FROM AN UPPER DRIVE BAY :
1 Grasp tab located in the front-center of the metal shield.
2 Pull the shield out by the tab in a straight motion to avoid tearing the tab
from the shield.
T O REPLACE A METAL SHIELD OVER AN UPPER DRIVE BAY :
Align the shield so that it fits snugly with the drive bay and press in gently
until the shield is flush with the surface of the bay.