Dell Precision T3400 (Late 2007) - Manual (Page 218)

218
Adding and Replacing Parts
Removing a Drive-Panel Insert
NOTICE:
Drive-panel inserts may contain screws on the inside. You can attach the
screws to new drives that do not have any screws.
NOTICE:
To avoid breaking the drive-panel insert tab, do not pull the insert more
than approximately 1 cm (½ inch) away from the drive panel before sliding the tab
out of the slot.
1 On the inside of the drive panel, pinch the two drive-panel insert release
tabs together and pull the insert out and to the right just enough to release
it from the drive panel.
2 Set the drive-panel insert aside in a secure location.
Installing a Drive-Panel Insert
1 Place the drive-panel insert tab into the drive-panel slot.
2 Pinch the drive-panel insert release tabs and press the drive panel insert
into place.
1 drive panel 2 drive-panel insert
3 drive-panel insert release
tabs (2) 4 drive-panel insert tab in tab slot
1
2
3
4