Dell Latitude 10 (Late 2012) - Manual (Page 17)

6. Lift the retention clasp in an upward direction and release the fingerprint reader cable outward to remove it from
the system board. Lift the base cover away from the computer.
Installing the Base Cover
1. Attach the fingerprint reader flex cable from the base cover to the system board.
2. Attach the base cover to the computer.
3. Push the edges of the base cover into the securing clips until they are fully engaged.
4. Tighten the screws to secure the base cover.
5. Install the battery.
6. Follow the procedures in After Working Inside Your Computer.
Removing the Front Camera
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the:
a) battery
b) base cover
3. Lift up the connector latch and disconnect the camera cable. Remove the screw that secures the camera module
to the computer. Remove the camera module from the computer.
17