Dell PowerEdge VRTX - Manual (Page 32)

Figure 7. Removing and Installing a Cooling Shroud
1. tabs (4) 2. cooling shroud
3. slots on the chassis (4)
Installing A Server Module
NOTE: Ensure that you remove the server module partitions before installing the M820 server
module. For information about removing the server module partitions, see Dell PowerEdge VRTX
Enclosure Owner’s Manual at dell.com/poweredgemanuals.
1. If you are installing a new server module, remove the plastic cover from the I/O connector(s) and
save for future use.
2. Orient the server module so that the handle is on the left side of the server module.
3. Align the server module with the server module slot and the guide rails on the enclosure.
4. Using both hands, slide the server module into the enclosure until the module release handle
engages and locks the server module in place.
5. If applicable, reinstall the front bezel.
Hard Drives/SSDs
• The system supports up to four 2.5 inch SAS hard drives/PCIe SSDs.
• All drives connect to the system board through the SSD/SAS hard-drive backplane.
• Hard drives/PCIe SSDs are supplied in special hot-swappable drive carriers that fit in the drive slots.
• All empty drive slots must have hard-drive blanks installed.
The following table lists the supported hard drive/SSD configurations.
32