Dell PowerEdge VRTX - Manual (Page 53)

3. Install an I/O connector cover on the I/O connector(s) at the back of the board.
WARNING: The processor and heat sink can become extremely hot. Be sure the processor
has had sufficient time to cool before handling.
WARNING: The memory modules are hot to the touch for some time after the system has
been powered down. Allow time for the memory modules to cool before handling them.
Handle the memory modules by the card edges and avoid touching the components.
NOTE: If you are removing more than one hard drive/SSD, label them so you can replace them
in their original locations.
4. Remove the following components:
a) hard drives/SSDs
b) hard-drive backplane(s)
c) cooling shroud
d) PCIe mezzaninecards
CAUTION: Do not lift the system board assembly by grasping a memory module, processor,
or other components.
5. Hold the server module chassis with one hand, lift and pull the system board retention pin with the
other hand, and then slide the system board out of the open end of the chassis.
6. Ensure that the I/O connector cover is still in place on the I/O connector at the back of the board.
7. Remove the memory modules and memory module blanks.
8. Remove the processor(s).
53