Dell PowerEdge R210 - Manual (Page 38)

6. Remove the four screws that secure the control panel board to the chassis.
Figure 3-19. Control Panel Removal
Installing the Control Panel Assembly
1. Align the screw holes on the control panel board with the holes on the chassis.
2. Replace the screws on the control panel assembly. See Figure 3 -19 .
3. Connect the control panel cable to the control panel board.
4. Connect the USB connector cable.
5. Replace the hard drive. See Installing a Hard Drive .
6. Close the system. See Closing the System .
7. If applicable, replace the front bezel. See Installing the Front Bezel .
8. Reconnect the system to the power source and turn on the system and attached peripherals.
System Board
Removing the System Board
1 control panel cable 2 USB connector cable
3 USB connectors (4) 4 screws (4)
5 LED display module 6 control panel board
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as
authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not
authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
CAUTION: If you are using the Trusted Program Module (TPM) with an encryption key, you may be prompted to create a recovery key during
program or system setup. Be sure to create and safely store this recovery key. If you replace this system board, you must supply the recovery
key when you restart your system or program before you can access the encrypted data on your hard drives.