Camera, Removing the camera – Dell Inspiron 13z (N301z, Mid 2010) User Manual
Page 11
Back to Contents Page
Camera
Dell™ Inspiron™ M301Z/N301Z Service Manual
Removing the Camera
1.
Follow the instructions in
Before You Begin
.
2.
Remove the display assembly (see
Removing the Display Assembly
).
3.
Remove the display bezel (see
Removing the Display Bezel
).
4.
Remove the two screws that secure the WLAN antenna to the display cover.
5.
Disconnect the camera cable from the connector on the camera module.
6.
Lift the WLAN antenna off the display panel.
7.
Lift the camera module off the display cover.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1 screws (2)
2 camera module
3 WLAN antenna
4 camera cable connector