Speaker, Removing the speaker – Dell Inspiron 13z (N301z, Mid 2010) User Manual
Page 46
Back to Contents Page
Speaker
Dell™ Inspiron™ M301Z/N301Z Service Manual
Removing the Speaker
1.
Follow the instructions in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the module cover (see
Removing the Module Cover
).
4.
Remove the keyboard (see
Removing the Keyboard
).
5.
Remove the palm rest (see
Removing the Palm Rest
).
6.
Lift the connector latches and pull the pull-tabs to disconnect the hard- drive cable and the status light board cable from their connectors on the system
board.
7.
Peel the status light board cable that is glued on the speaker.
8.
Disconnect the speaker cable from the connector on the system board.
9.
Remove the two screws that secure the speaker to the computer base.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1 hard-drive cable
connector
2 status light board
cable connector