Replacing the display assembly – Dell Inspiron 13z (N301z, Mid 2010) User Manual
Page 21
11.
12.
Disconnect the display cable and the camera cable from their connectors on the system board.
13.
Make a note of the routing of the Mini-Card antenna cables and remove the cables from the routing guides.
14.
Remove the six screws (three on each side) that secure the display assembly to the computer base.
15.
Lift and remove the display assembly off the computer base.
Replacing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Place the display assembly in position and replace the six screws (three on each side) that secure the display assembly to the computer base.
3.
Route the Mini-Card antenna cables through the slot on the computer base.
4.
Replace the hinge caps (see
).
5.
Connect the display cable and the camera cable to their connectors on the system board.
6.
Replace the Bluetooth card (see
Replacing the Bluetooth Card
).
7.
Replace the palm rest (see
Replacing the Palm Rest
).
8.
Replace the keyboard (see
Replacing the Keyboard
).
9.
Turn the computer over and connect the antenna cables to the Mini- Card(s) (see
step 7
of
Replacing the Mini-Card(s)
).
10.
Replace the memory module(s) (see
Replacing the Memory Module(s)
).
11.
Replace the module cover (see
Replacing the Module Cover
).
12.
Replace the battery (see
Replacing the Battery
).
1 display assembly
2 screws (6)
3 camera cable
connector
4 display cable
connector
5 Mini-Card antenna cables