Dell OptiPlex 360 (Late 2008) - Manual (Page 9)

Before Working on Your Computer 9
1
Before Working on Your Computer
This document provides procedures for removing and installing the
components in your computer. Unless otherwise noted, each procedure
assumes that:
• You have performed the steps in "Before Working on Your Computer" on
page 9.
• You have read the safety information that shipped with your computer.
• When replacing a component, you have already removed the original, if
installed.
NOTE: The color of your system and certain system components may appear
differently than shown in this document.
Recommended Tools
The procedures in this document may require the following tools:
• Small flat-blade screwdriver
• Phillips screwdriver
• Small plastic scribe
• Flash BIOS update (see the Dell Support website at
support.dell.com)
Before Working on Your Computer
Use the following safety guidelines to help protect your computer from
potential damage and to help to ensure your own personal safety.
WARNING: Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your
computer. Damage due to servicing that is not authorized by Dell is not covered by
your warranty.