Remove and replace the fan and shroud assembly – Dell OptiPlex 960 (Late 2008) User Manual
Page 107
12.
If the system contained a wireless card that was removed in a previous step, replace the card (see
Internal Wireless Card - Installation
).
13.
Reroute cables through guides on the fan shroud.
14.
Replace the optical drive (see
Replacing or Installing an Optical Drive
).
15.
Replace the hard drive and shroud assembly (see
Replacing the Hard Drive and Shroud Assembly
).
16.
Perform the procedure
After Working on Your Computer
.
Remove and Replace the Fan and Shroud Assembly
The fan and shroud assembly can be removed and replaced without removing the heatsink.
1.
Perform the procedure
Before Working on Your Computer
.
2.
Remove the hard drive and shroud assembly (see
Removing the Hard Drive and Shroud Assembly
).
3.
Remove the optical drive (see
Removing an Optical Drive
).
4.
If an internal wireless card is installed, unplug the card from the system board and move it and wireless card cable away from the fan shroud (see
Internal Wireless Card - Removal
).
5.
Remove cables routed through guides on the fan shroud.
6.
Disconnect the two fan cables from the system board (see
System Board Components
).
7.
Remove the four screws that secure the fan and shroud assembly to the heatsink.
8.
Lift the fan and shroud assembly out of the chassis.
1 heatsink assembly
2 captive screw in housing (4)
3 fan cable connectors (2)