Replacing the i/o assembly – Dell OptiPlex 960 (Late 2008) User Manual
Page 43
Replacing the I/O Assembly
To replace the I/O assembly, do the following:
1.
Perform the procedure
Before Working on Your Computer
.
2.
Remove the bezel:
a.
Lift the three retention tabs to release the top edge of the bezel.
b.
Roll the bezel down and lift it from the chassis.
3.
Feed the I/O assembly cables into the front of the chassis through the opening for the I/O assembly until the assembly is in place. Ensure that the
securing tab points toward the right (toward the grill).
1
I/O assembly
2
securing tab
3
I/O assembly cables/connectors
NOTE:
Use the guides on the I/O assembly bracket to help position the I/O assembly in place, and use the notch on the I/O assembly bracket to
help seat the panel.
1
bezel
2
retention tabs (3)