Dell OptiPlex 960 (Late 2008) User Manual
Page 93
3.
If you are installing a new card, remove the filler bracket to create a card- slot opening. Then continue with
.
4.
If you are replacing a card that is already installed in the computer, remove the card. If necessary, disconnect any cables connected to the card. Then
continue with
5.
Prepare the card for installation.
6.
Place the card in the connector and press down firmly. Ensure that the card is fully seated in the slot.
7.
Before closing the card retention latch, ensure that:
l
The tops of all cards and filler brackets are flush with the alignment guide
l
The notch in the top of the card or filler bracket fits around the alignment guide
8.
Secure the card(s) by closing the card retention latch and snapping it into place.
9.
Connect any cables that should be attached to the card.
10.
Perform the procedure
After Working on Your Computer
).
11.
If you installed a sound card:
a.
Enter system setup, select Integrated Audio from the Onboard Devices group, and change the setting to Off (see the Dell
™
Technology Guide).
b.
Connect external audio devices to the sound card's connectors. Do not connect external audio devices to the line-in connector on the back panel
of the computer.
12.
If you installed a network adapter card and want to turn off the integrated network adapter:
a.
Enter system setup, select Integrated NIC from the Onboard Devices group, and change the setting to Off (see the Dell
™
Technology Guide).
1
card retention latch
2
release tab
3
card
4
card-edge connector
5
card connector
CAUTION:
Some network adapters automatically start the computer when they are connected to a network. To guard against electrical shock, be
sure to unplug your computer from its electrical outlet before installing any cards.
NOTE:
See the documentation that came with the card for information on configuring the card, making internal connections, or customizing it for
your computer.
1 card fully seated
2 card not fully seated
3 filler bracket within slot
4 filler bracket caught outside of slot
NOTICE:
Do not route card cables over the cards. Cables routed over the cards can prevent the computer cover from closing properly or cause
damage to the equipment.
NOTE:
See the documentation that came with the card regarding the card's cable connections.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.