Dell OptiPlex 960 (Late 2008) - Manual (Page 95)

11. If you removed a network-adapter card connector:
a. Enter system setup, select Integrated NIC from the Onboard Devices group, and change the setting to On (see the Dell
™
Technology Guide).
b. Connect the network cable to the integrated network connector on the back panel of the computer.
PCIe and DVI Cards
Your computer supports one low-profile PCIe x16 card.
If you are replacing a PCIe card with a different type of PCIe card, remove the current driver for the card from the operating system. See the documentation
that came with the card for information.
Installing a PCIe x16 Card or DVI Card
1. Perform the procedure Before Working on Your Computer .
2. Gently lift the release tab on the card retention latch from the inside and pivot the latch open.
3. If you are installing a new PCIe x16 card or DVI card, remove the filler bracket to create a card-slot opening. Then continue with step 4 .
4. If you are replacing a PCIe x16 card or DVI card, remove the card (see Removing a PCIe x16 Card or DVI Card ). If necessary, disconnect any cables
connected to the card. Then continue with step 5 .
5. Prepare the card for installation.
6. Place the card in the connector and press down firmly. Ensure that the card is fully seated in the slot.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
NOTE: See the documentation for the card for information about the card's cable connections.
NOTE: For PCI card locations, see System Board Components .
CAUTION: Some network adapters automatically start the computer when they are connected to a network. To guard against electrical shock, be
sure to unplug your computer from its electrical outlet before installing any cards.
NOTE: See the documentation that came with the card for information on configuring the card, making internal connections, or customizing it for
your computer.
1 PCIe x16 card PCIe x16 DVI-card 2 card connector
3 system board card connector