Dell OptiPlex GX1 - Manual (Page 14)

Introduction: Dell OptiPlex GX1 and GX1p Midsize Managed PC Systems
file:///C|/infodev/2013/eDoc/OpGX1/SIG/introduc.htm[2/21/2013 12:07:18 PM]
easiest to attach before you set up your computer and connect the back-panel cables.
Attach the stand as follows:
1. Turn the computer onto its right side, so that the drive bays are at the bottom.
2. Fit the stand onto what was the left side of the computer.
Position the stand as shown in Figure 4. Align the large round hole in the stand with the securing
button on the side of the cover, and align the captive thumbscrew in the stand with the screw hole in
the cover.
Figure 4. Attaching the Optional Stand for Vertical Orientation
As you lower the stand into place, make sure that the locator pin (see Figure 4) fits into the corner hole
of the hole pattern as shown. When the stand is in place, tighten the thumbscrew.
3. Rotate the computer so that the stand is at the bottom and the drives are at the top.
To remove the stand, turn the computer over so the stand is at the top, loosen the screw, lift the stand away,
and place the computer in a horizontal position.
ENERGY STAR® Compliance
Certain configurations of Dell computer systems comply with the requirements set forth by the Environmental
Protection Agency (EPA) for energy-efficient computers. If the front panel of your computer bears the
ENERGY STAR® Emblem (see
Figure 5 ), your original configuration complied with these requirements and
all ENERGY STAR power management features of the computer are enabled. To disable or change the
operation of these features, you must change the setting for the Power Management option in the System
Setup program. For instructions, see "
Using the System Setup Program ."
NOTES: As an ENERGY STAR® Partner, Dell Computer Corporation has determined that this
product meets the ENERGY STAR guidelines for energy efficiency.
Any Dell computer bearing the ENERGY STAR® Emblem is certified to comply with EPA Energy
Star requirements as configured when shipped by Dell. Any changes you make to this
configuration (such as installing additional expansion cards or drives) may increase the system's
power consumption beyond the limits set by the EPA's ENERGY STAR® Computers program.