Dell OptiPlex GX1 - Manual (Page 79)

Installing Drives: Dell OptiPlex GX1 and GX1p Midsize Managed PC Systems
file:///C|/infodev/2013/eDoc/OpGX1/SIG/drives.htm[2/21/2013 12:07:25 PM]
Removing and Replacing Front-Panel Inserts
Empty drive bays contain a front-panel insert to protect the inside of the computer from dust particles and to
ensure proper airflow within the computer. Before you install a drive in an empty drive bay, you must first
remove the front-panel insert.
To remove the insert covering a 5.25-inch bay, follow these steps.
CAUTION: Before you remove the computer cover, see " Safety First — For You and Your
Computer ."
1. Turn off the system, including any attached peripherals, and disconnect all the AC power cables from
their power sources.
2. Remove the computer cover as instructed in " Removing the Computer Cover ."
3. Lay the computer cover upside down on a flat work surface, with the front of the cover facing toward
you.
4. With your thumbs, press in each end of the insert until it snaps free of the cover (see Figure 2).
Figure 2. Removing the Front-Panel Insert for a 5.25-Inch Bay
To replace a front-panel insert for a 5.25-inch bay, work from inside the cover. Position the insert behind the
bay opening, insert the two ring-tabs (one on each end of the insert) over the posts on the inside of the
opening, and firmly press both ends of the insert into place (see Figure 2).