Dell OptiPlex GX1 - Manual (Page 84)

Installing Drives: Dell OptiPlex GX1 and GX1p Midsize Managed PC Systems
file:///C|/infodev/2013/eDoc/OpGX1/SIG/drives.htm[2/21/2013 12:07:25 PM]
8. Connect the appropriate interface cable to the interface connector on the back of the drive (see Figure
9).
If your system came with an EIDE CD-ROM or tape drive, use the spare connector on the existing
interface cable. Otherwise, use the EIDE interface cable provided in the drive kit.
Figure 9. Attaching Diskette Drive or Tape Drive and DC Power Cables
9. For an EIDE tape drive or CD-ROM drive, connect the other end of the interface cable to the interface
connector labeled "IDE2" on the system board.
For a diskette drive or non-EIDE tape drive, connect the cable from the drive to the interface connector
labeled "DSKT" on the system board.
For a drive that comes with its own controller card, connect the other end of the interface cable to the
controller card.
Check all cable connections. Fold cables out of the way to provide airflow for the fan and cooling vents.
10. If the 5.25-inch drive bay was previously empty, remove the front-panel insert from the computer
cover.
See " Removing and Replacing Front-Panel Inserts ."
11. Replace the computer cover .
If the bezel on your drive is not flush with the bezel on your computer, remove the drive and adjust the
position of the drive on the bracket, making sure to insert and tighten the screws in the order marked.
Replace the drive in the drive bay, and then replace the computer cover.
12. Reconnect your computer and peripherals to an electrical outlet, and turn them on.
NOTE: If Enabled, the Chassis Intrusion option will cause the following message to be displayed
at the next system start-up:
ALERT! Cover was previously removed.
13. Enter the System Setup program and update your system configuration information.