Dell Studio One 19 (1909, Early 2009) - Manual (Page 12)

Replacing the Support Assembly
1. Follow the instructions in Before You Begin .
2. Reconnect the following cables to the LCD panel:
l LVDS cable from LVDS connector
l touch pad cable from the touch pad connector
l touch panel cable from the touch panel module
3. Replace the fourteen screws that secure the support assembly to the LCD panel.
4. Replace the hard drive (see Replacing the Hard Drive ).
5. Replace the power supply unit (see Replacing the Power Supply Unit ).
6. Replace the optical drive (see Replacing the Optical Drive ).
7. Replace the inverter (see Replacing the Inverter ).
8. Replace the side I/O panel (see Replacing the Side I/O Panel ).
9. Replace the system board (see Replacing the System Board ).
Back to Contents Page
1 touch pad cable 2 LVDS cable
3 touch panel cable 4 LCD panel