Processor, Removing the processor – Dell Studio One 19 (1909, Early 2009) User Manual
Page 27
Back to Contents Page
Processor
Dell Studio One 19/1909 Service Manual
Removing the Processor
1.
Follow the procedures in
Before You Begin
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
Remove the shield (see
Removing the Shield
).
4.
Remove the stand (see
Removing the Stand
).
5.
Remove the back I/O panel (see
Removing the Back I/O Panel
).
6.
Remove the processor heat sink (see
Removing the Heat Sink
).
7.
Press and push the release lever down and out to release it from the tab that secures it.
8.
Open the processor cover.
9.
Lift up the processor to remove it from the socket, place it aside in a safe and secure place.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Do not perform the following steps unless you are familiar with hardware removal and replacement. Performing these steps
incorrectly could damage your system board. For technical service information, see the Setup Guide.
WARNING:
The heat sink may be very hot during normal operation. Be sure that it has had sufficient time to cool before you touch it.
NOTE:
Unless a new heat sink is required for the new processor, reuse the original heat sink when you replace the processor.
1 processor cover
2 processor
3 processor socket 4 release lever
CAUTION:
When removing or replacing the processor, do not touch any of the pins inside the socket or allow any objects to fall on the pins in the
socket.